The RD series amplifiers deliver a ton of power with a low distortion rate. We used the best parts we could find to give you a top quality amplifier that anyone would be proud to show off. With their clean looks and sleek finish, they’ll look good in any install. So whether it’s an elegant sound quality setup or a high powered SPL vehicle, the RD series amplifiers have you covered.
Features
- 4/3/2 channel bridgeable class-AB amplifier
- MOSFET PWM power supply
- 4 ohm bridged or/and 2 ohm stereo
- 18dB octave crossover slope
- Variable crossover frequency with FULL/LPF/HPF selectable switch
- Multi-way protection circuitry (Thermal/over current/speaker short/speaker DC protection)
- RCA line input and output
- Tested voltage & THD: 14.4V & less than 0.05% THD
- Operating voltage : DC10V~16V power input
MSRP
$299.00
Specifications
| RMS power, 4 ohm stereo | 55w x 4ch |
| RMS power, 2 ohm stereo | 75w x 4ch |
| RMS power, 4 ohm bridged | 150w x 2ch |
| Signal to Noise Ratio | <95db |
| Low pass crossover | 50hz ~ 500hz |
| High pass crossover | 50hz ~ 500hz |
| Bass boost @ 45Hz | - |
| Frequency response | 10Hz ~ 30KHz (+/-1dB) |
| T.H.D @ 4 ohms | <0.05% |
| Channel separation | 75dB |
| Fuse rating | 25A x 2 |
| Input sensitivity | 200mV~6V (+/- 5%) |
| Dimensions | 222(W) x 52(H) x 230(L)mm |
