The RD series amplifiers deliver a ton of power with a low distortion rate. We used the best parts we could find to give you a top quality amplifier that anyone would be proud to show off. With their clean looks and sleek finish, they’ll look good in any install. So whether it’s an elegant sound quality setup or a high powered SPL vehicle, the RD series amplifiers have you covered.
Features
- Digital class-D linkable mono block amplifier
- MOSFET PWM power supply
- Daisy-chain through output RCA
- Heavy duty cooper layer double sided epoxy PCB
- Stable into 1 ohm and 2 ohm parallel amplifier connection availability
- 24 dB low pass (LPF) crossover variable
- 18 dB bass boost equalization control variable
- 180 degree variable adjustable phase shift
- 24 dB subsonic filter variable
- Selectable Switch for MASTER and SLAVE Operation
- Speaker short, over current, thermal, and DC protection circuit
- RCA line input and line output
- 2 x 0 guage (AWG) battery input connectors
- Efficiency: 86% at 4 ohm, 100 Hz
- Tested voltage & THD : 14.4V and less than 1% THD at 4 ohm RMS watt
- Operating voltage: DC 10V ~ 18V power input
- Damping factor: better 350 into 1 ohm
- Wired remote controller
Specifications
| RMS power, 2 ohm linkable/dual mono | |
| RMS power, .5 ohms mono | 3000 |
| RMS power, 1 ohm mono | 2000 |
| RMS power, 2 ohm mono | 1000 |
| RMS power, 4 ohms mono | 500 |
| Signal to Noise Ratio | >100dB |
| Low pass frequency crossover | 35Hz~300Hz |
| Subsonic filter | 10Hz~60Hz |
| Bass boost @ 45Hz | 0~18dB |
| Phase shift control | 0~180 degree |
| Frequency response | 10Hz~350Hz (+/- 1dB) |
| T.H.D @ 4 ohm | <0.1% |
| Efficiency @ 4 ohm | 86% |
| Fuse rating | 300 amps |
| Input Sensitivity | 200mV to 6V (+/- 5%) |
| Dimensions |
